Krohne M10 Converter H250-H 54 Ex II2G EN User Manual

Supplementary Installation and Operating InstructionsVariable-area flowmeters H250/H54Signal converter M10 of hazardous-dutydesign EEx dPTB 01 ATEX 11

Signal converter M10-EEx d – Supplementary instructions 11/2002 10 8.2 Dismantling 8.2.1 General Should it prove necessary to open the Flameproo

11/2002 Signal converter M10-EEx d – Supplementary instructions 11 Attachment A.1 EC Type Test Certificate PTB 01 ATEX 1154

Signal converter M10-EEx d – Supplementary instructions 11/2002 12 Attachement A.1 EC Type Test Certificate PTB 01 ATEX 1154 Physikalisch-Tec

11/2002 Signal converter M10-EEx d – Supplementary instructions 13

Signal converter M10-EEx d – Supplementary instructions 11/2002 14 Physikalisch-Technische Bundesanstalt PTB Brunswick and Berlin (13) S c

11/2002 Signal converter M10-EEx d – Supplementary instructions 15

Signal converter M10-EEx d – Supplementary instructions 11/2002 16 Physikalisch-Technische Bundesanstalt PTB Brunswick and Berlin Schedule to

11/2002 Signal converter M10-EEx d – Supplementary instructions 17

Signal converter M10-EEx d – Supplementary instructions 11/2002 18 Physikalisch-Technische Bundesanstalt PTB Brunswick and Berlin Schedule to

11/2002 Signal converter M10-EEx d – Supplementary instructions 19 Attachment A.2 Declaration of Conformity

Signal converter M10-EEx d – Supplementary instructions 11/2002 2 Contents 1 General safety information ...

Signal converter M10-EEx d – Supplementary instructions 11/2002 20 If you need to return a device for testing or repair to KROHNE Your instrume

11/2002 Signal converter M10-EEx d – Supplementary instructions 3 1 General safety information These additional “Ex“ Instructions apply to the

Signal converter M10-EEx d – Supplementary instructions 11/2002 4 2 Safety-relevant type code The safety-relevant type code is made up of the

11/2002 Signal converter M10-EEx d – Supplementary instructions 5 3.5 Cable entries / sealing plugs Cable entries and sealing plugs must, in re

Signal converter M10-EEx d – Supplementary instructions 11/2002 6 4 Marking The variable-area flowmeters are identified by an adhesive label or

11/2002 Signal converter M10-EEx d – Supplementary instructions 7 5.1 Electrical connection 5.1.1 General Insulation rating The insulation of v

Signal converter M10-EEx d – Supplementary instructions 11/2002 8 • Connect the shields by the shortest possible route to the press-fitted U-cla

11/2002 Signal converter M10-EEx d – Supplementary instructions 9 6 Initial startup Check the following points before initial startup: • Suita