Krohne OPTIFLEX 1300C EN User Manual download pdf (Page 18)

3 INSTALLATION

OPTIFLEX 1300 C

www.krohne.com 03/2014 - 4000172306 - HB OPTIFLEX 1300 R07 en

3.3 Transport

3.4 Pre-installation requirements

• Make sure that there is sufficient space on all sides.

• Protect the signal converter from direct sunlight. If necessary, install the weather protection

accessory.

• Do not subject the signal converter to heavy vibrations. The devices are tested for vibration

and agree with EN 50178 and IEC 60068-2-6.

Figure 3-2: How to hold the device

Figure 3-3: How to hold the device

1 Remove the converter before you lift the device with a hoist.

2 Wind cable probes greater than 400 mm / 16¨ in diameter.

3 Do not hold the probe when you lift the device.

4 Do not wind the flexible conduit less than 330 mm / 13¨ in diameter.

WARNING!

If you do not lift the device carefully, you can cause damage to the probe.

INFORMATION!

Obey the precautions that follow to make sure that the device is correctly installed.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 191 192

No comments

Krohne OPTIFLEX 1300C EN User Manual Page 18